For EMI shielding and grounding inside precision electronics, the benefit of the Conductive Cloth Tape Series is a flexible roll format that follows compact locations. LX-DDB uses 260T plain-weave conductive cloth with conductive acrylic adhesive, and its product page lists surface resistance at ≤ 100 mΩ. When a test report arrives, align probe configuration, specimen geometry, weave direction and contact conditions before comparing values so the low-resistance feature becomes a useful sampling decision.
Read the resistance value with its test method
Buyers searching for custom plain-weave conductive fabric tape still need a report with comparable conditions. A surface-resistance field can narrow the candidate set, but a value without measurement direction and contact setup does not represent the full grounding path after installation. The existing grounding-path article covers overlap and electrical continuity. This article adds a focused way to read report fields and compare samples.
260T plain weave supports flexible wrapping
The product page identifies a 260T plain-weave conductive-cloth substrate with conductive acrylic adhesive. The flexible cloth can bend and suit custom die cutting, which helps engineers position narrow grounding strips around LCD backlight modules, handheld wireless modules and compact electronics. Electrical continuity still needs verification on the final cut geometry and target surface.
A comparable report identifies four test conditions
Ask the supplier to identify the probe or electrode arrangement, specimen length, width and thickness, measurement direction relative to the weave, and the contact force and temperature. These fields show whether two results were produced under matching conditions and help prevent sheet resistance, two-point resistance and installed overlap resistance from being treated as the same quantity.
The four-point-probe equation checks report boundaries
The NIST sheet-resistance document gives Rs = (V/I) × Ka × FT × F(t/S). Rs is sheet resistance, V is measured voltage and I is applied current. Ka corrects probe configuration and specimen geometry, FT corrects measurement temperature, and F(t/S) corrects thickness t relative to probe spacing S. The model applies to a uniform sheet under defined conditions. LX-DDB is a woven cloth and conductive-adhesive composite, so weave direction, boundaries and contact state may affect the result; the equation cannot create a product guarantee or predict assembled EMI shielding.
Adhesion and temperature define whether the sample stays in place
The LX-DDB product page also lists surface adhesion at ≥ 1.0 kg/in, 180-degree peel strength at ≥ 1.3 kgf/in, long-term operation at 80°C and short-term exposure at 120°C. These facts support a high-temperature attachment discussion, while the actual substrate, cleaning, lamination and thermal cycle still require application testing.
Send comparable conditions with the sample request
Engineers and buyers in precision electronics can provide the bonding substrate, effective grounding area, die-cut width, bend location, operating temperature and intended measurement method, then request reports with the same direction, dimensions and contact conditions. LX-DDB offers low surface resistance and flexible wrapping for compact EMI grounding samples, with final continuity and EMC performance verified on the assembled device.
#ConductiveClothTape #EMIShielding #SurfaceResistance #ElectronicsGrounding #DieCutting

